all information needed is provided in picture Scuff plates are the plastic plate
ID: 3044399 • Letter: A
Question
all information needed is provided in picture
Scuff plates are the plastic plates at the base of the door f 6.9.2 mobiles. They are manufactured in an injection moldin (one on each of two machines) are used to make these plates. Each two cavities, one for the left-hand plate and one for the right-ha injection gun is hooked up to each clamp. The clamps close and the mold material is injected into the cavities. When the clam released. The clamps and injection of molding material are operated by auto- matic controls. Once the parts are removed from the cavities, an operator must clean the cavities, if necessary, to ensure the quality of the next run. Each clamp is run by one operator throughout an entire shift. Some rotation of operators occurs between shifts. g process. Two clamps clamp has nd plate. An p opens, two parts are A critical characteristic in the molding process is the length of the parts. Each rt has five pinholes to allow for automobile assembly; part length is evaluated by measuring the distance from the end of the plate to the fifth pinhole. The fol- lowing sampling and subgrouping plan is proposed: For each machine, measure three successively manufactured left-hand parts and right-hand parts every two hours throughout eight successive shifts. Four separate range and X-bar charts will be constructed. There will be range and X-bar charts for right-handed parts from machine 1 and a separate pair of charts for left-handed parts from machine 1. The same two sets of charts will also be constructed for machine 2. a. How would differences in the average dimension of right-hand and left hand parts be noted on the four sets of control charts? b. How would different within-machine variations affect the four sets of charts? c. Will it be possible to note any differences between shift operation? What kinds of differences might be detected? If molding materials affect part dimensions, how will these effects influ ence the behavior of the range and X-bar charts? d.Explanation / Answer
soln:
a)differences can be compared by comparing the standard deviations calculated from the x bar charts, earlier the deviation were measured by the considering the length of the range interval but nowadays because of computers calculating standard deviations became easier, and calculating differences became accurate.
b)different within machine variations affects the four sets of charts as the range or the standard deviations of all the pair of charts would differ.
c)yeah ! it is absolutely possible to detect the difference in shift operation if the graph shows somewhat same values for a period and then the change between shifts, can change the average value that one got previously.
d)an irregular trend in the r graph or x bar graph can show the diffrence in the molding materials, by showing variations in the trend of the graph.
Related Questions
Navigate
Integrity-first tutoring: explanations and feedback only — we do not complete graded work. Learn more.