Task 3: The following figure shows the configuration details of a CISCO switch.

Question

Task 3: The following figure shows the configuration details of a CISCO switch. When a ping command was issued to access the default gateway, it was not successful. What is a possible reason for this? 8witch# configure ter inal Enter configuration commands, one per line. End with ONTL/ Switch (config)# interface vlan 1 Switch (config-if)# ip address 192.168.10.2 255.255.255.0 Switch(config-if) # oxit switch (config)# ip default-gateway 192.168.10.220 Bwatch (config) # orit Switch# %SYS-5-OONETG_T: Oonfigured from console by console switch# ping 192.168.10.220 type escape #equence to abort. Banding 5, 100-byte 1CHP Echos to 192.168.10.220, timeout B 2 geconds: Success rate is 0 percent (o/s)

Explanation / Answer

Hi!

Hope this helps.

I believe your problem is that you're not allowing vlan 1 over the trunk.

Assuming the server is on vlan 1:

conf t

interface FastEthernet1/0/24

switchport trunk allowed vlan add 1

Thanks

Related Questions

Navigate

• Browse (All)
• Browse T
• Subjects

---

---

Integrity-first tutoring: explanations and feedback only — we do not complete graded work. Learn more.