Which of the following command sets the second password to enable increate passw

Question

Which of the following command sets the second password to enable increate password What command do you type to save the configuration stored in RAM to NVRAM? delete NVRAM delete startup-configuration erase NVRAM erase start You are troubleshooting a connectivity problem in your corporate network and want to isolate the problem. You suspect that a router on the route to an unreachable network is a fault. What IOS user problem. You suspect that a router on the route to an unreachable network is a fault. What IOS user exec command should you issue? Router ping Router trace Router show ip route Router show interface Router show cdp neighbors Which of the following protocols are used to configure trucking on a switch? VLAN Trunk protocol VLAN 802.1Q Which switching technology reduces the size of a broadcast domain? ISL 802.1Q VLANs STP Which command will configure a switch port to use the IEEE standard method of inserting VLAN membership information into Eth

Explanation / Answer

Dear Student,

Here are the answers...

Ans.1- Option (C) enable secret Cisco is correct.

enable secret command Specifies an additional layer of security over the enable password command. To set the enable secret password, we have to use the enable secret password command from global configuration mode.

-----------------------------------------------------------------------------------------------------------------------------------

Ans.2:- Given options are wrong. Kindly Verify the question again.

By the way the right anser is------ To copy the running-config to NVRAM use the copy running-config startup-config comand.

-----------------------------------------------------------------------------------------------------------------------------

Ans:3:- Option (A) is correct.

router>ping

ping command is used to check the communication from a device to another device on a network.It also shows the time taken for a packet to reach the host.

-----------------------------------------------------------------------------------------------------------------------------------

Ans:4- Option No.(D) is 802.1Q is coorect.

IEEE 802.1Q is a protocol which carries VLAN traffic on an Ethernet.

----------------------------------------------------------------------------------------------------------------------------------------

Ans:5: The Option: (C) is correct.

VLAN technology redueces the size of a broadcast domain.

What is VLAN.??

A VLAN is a group of devices on one or more LANs that are configured to communicate as if they were attached to the same wire, when in fact they are located on a number of different LAN segments. Because VLANs are based on logical instead of physical connections, they are extremely flexible.

-----------------------------------------------------------------------------------------------------------------------------------------

Ans:6 Option: (C) is correct.

"Switch(config-if)# switchport trunk encapsulation dot1q" command will configure a switch port to use the IEEE standard method of inserting VLAN membership information into Ethernet frames.

--------------------------------------------------------------------------------------------------------------------------------------

Kindly Check and Verify Thanks...!!!

Related Questions

Navigate

• Browse (All)
• Browse W
• Subjects

---

---

Integrity-first tutoring: explanations and feedback only — we do not complete graded work. Learn more.