Bob has been given the task of changing the IP Address and enabling telnet remot

Question

Bob has been given the task of changing the IP Address and enabling telnet remote access on a CISCO 2950 enterprise switch. The current IP address is 172.25.2/16 the new IP address is 10.0.0.2/24 The enterprise switch has no password configured. a. Explain all of the commands needed for Bob to successfully accomplish the IP Address change and telnet remote access.

8 (10 points) Bob has been given the task of changing the IP Address and enabling telnet remote access on a CISCO 2950 enterprise switch. The current IP address is 172.25.2/16 the new IP address is 10.0.0.2/24 The enterprise switch has no password configured. a. Explain all of the commands needed for Bob to successfully accomplish the IP Address change and telnet remote access.

Explanation / Answer

Connect to the switch at 172.25.2/16

Then connect to the switch at 10.0.0.2/25

Then connect to the switch at 10.0.0.2/24 to make sure it worked, and to remove the staging IP.

We used third IP in between because cisco does not allow to configure secondary IP without primary IP configured.

Related Questions

Navigate

• Browse (All)
• Browse B
• Subjects

---

---

Integrity-first tutoring: explanations and feedback only — we do not complete graded work. Learn more.