Please provide some explenation with answer 14. Gear tooth wear can be measured

Question

Please provide some explenation with answer 14. Gear tooth wear can be measured using A. pins. C. string and a ruler. D. shims. micrometer. 15. The Egt gauge measures temperature. A. compressor inlet C. combustion B. exhaust D. oil 16. To aid the engine during acceleration many turbo shaft engines wiluse alof these methods, except C. bleed valves. A. bleed ports. variable stators. D. variable inlet guide vanes. 17. Which one of the following is not one of the lines interconnecting the gas producer and the power turbine governor on an Allison 250? A. Governor set pressure C. Compressor discharge pressure B. Regulated air pressure D. Governor servo pressure 18. On a T53 type engine, ignition is shutoff at approximately N1 speed when the starter switch is A. 12% C. 40% B. 25% D. 80% 19. On a Hiller 12, positive clutch engagement occurs at approximately C. 800 rpm. A. 300 rpm. D. 1200 rpm. B. 500 rpm. 20, Torquemeters are usually calibrated in A. percent. C. SHp. B. BHp. some power unit per revolution. Examination, Lesson 2

Explanation / Answer

14. string and a ruler

15.The Egt gauge measures exhaust temperature

16. variable inlet guide valves

17.D. governor servo pressure

18.40%

19.800rpm

20.Bhp

Related Questions

Navigate

• Browse (All)
• Browse P
• Subjects

---

---

Integrity-first tutoring: explanations and feedback only — we do not complete graded work. Learn more.