The setup routine runs once when you press reset: void setup() {initialize seria

Question

The setup routine runs once when you press reset: void setup() {initialize serial communication at 9600 bits per second: Serial. begin(9600); pin Mode(10, OUTPUT); pin Mode(11, OUTPUT);} the loop routine runs over and over again forever: void loop() {digital Write(10, HIGH); digital Write(11, HIGH); read the input on analog pin 0: int sensor Value - analog Read(A4); Convert the analog reading (which goes from 0 - 1023) to a voltage (0 float voltage - sensor Value times (5.0/1023.0);} For the following code what output pins are used? 10, 11 and A4 10, 11 and 9600 10 and A4 10 and 11

Explanation / Answer

10,11 are the output pins.

In the signal assignment these pins are assigned as outlined.

Related Questions

Navigate

• Browse (All)
• Browse T
• Subjects

---

---

Integrity-first tutoring: explanations and feedback only — we do not complete graded work. Learn more.