Question 1. 1. (TCO 1) The _____ is (are) used to determine which switch ports o

Question

Question 1.1. (TCO 1) The _____ is (are) used to determine which switch ports on a network need to be blocking in order to prevent loops from occurring. (Points : 2)        switch diameter
       spanning-tree algorithm
       spanning-tree traffic
       bridge priority Question 2.2. (TCO 1) The default STP mode on the Cisco 2960 switch is _____, which is based on the IEEE _____ standard. (Points : 2)        STP, 802.1D-2004
       PVST+, 802.1D-1998
       RSTP, 802.1w
       MSTP, 802.1D-2004 Question 3.3. (TCO 1) What is the Cisco technology that is used on access ports to bypass the listening and learning states? (Points : 2)        Nondesignated ports
       PortFast
       Rapid PVST+
       HSRP standby Question 4.4. (TCO 1) What is the initial approach that should be used to troubleshoot a broadcast storm in a switched network? (Points : 2)        Insert redundant links to replace the failed STP links.
       Remove redundant links in the switched network.
       Replace the cables on failed STP links.
       Replace all instances of STP with RSTP. Question 5.5. (TCO 1) When running HSRP, how would you verify if the router is the active or standby router?(Points : 2)        Show active
       Show protocols
       Show fhrp router
       Show standby Question 6.6. (TCO 2) The network engineer is putting EtherChannel on to the G0/1 and G0/2 interfaces. Which keyword will be used in the configuration commands? (Points : 2)        EtherChannel
       Port-channel
       Channel-group
       Ether-Channel Question 7.7. (TCO 2) _____ is(are) disabled by default. (Points : 2)        STP
       EtherChannel
       VLAN 1
       All of the above Question 8.8. (TCO 2) You are configuring two Cisco switches with redundant connections. To increase the available traffic bandwidth between the switches, you want to configure EtherChannel. SwitchA was already configured with
     SwitchA(config-if)# channel-group 2 mode desirable
Which protocol is being used? (Points : 2)        Link aggregation control protocol
       Port aggregation protocol
       Dynamic trunking protocol
       Gateway load balancing protocol Question 1.1. (TCO 1) The _____ is (are) used to determine which switch ports on a network need to be blocking in order to prevent loops from occurring. (Points : 2)        switch diameter
       spanning-tree algorithm
       spanning-tree traffic
       bridge priority

Explanation / Answer

1) Spanning tree algorithm

2) PVST+, 802.1D-1998

3) PortFast

4) Remove redundant links in the switched network. That is done manually.

5) show standby

6) Ethernet Channel

7) Ethernet Channel

8) Port aggregation protocol

Related Questions

Navigate

• Browse (All)
• Browse Q
• Subjects

---

---

Integrity-first tutoring: explanations and feedback only — we do not complete graded work. Learn more.